Where did Low Latency mode go of my master bus?

[Midiboy]

I know it changed from a Z to a D, but for the life of me, I either don't remember where it is, or it's gone from my master bus. Can anybody help out?

 

[chichogp]

Low latency mode is only available if your buffer is shorter than the dropout protection buffer.

 

[Midiboy]

Low latency mode is only available if your buffer is shorter than the dropout protection buffer.

Right. My buffer is 128. My DOP is 2048.

 

[SwitchBack]

Are we talking green Z or blue Z? Blue Z is only available in combination with recognised DSP enabled audio interfaces.

For green Z check under the Preferences/Audio Setup/Processing tab if Low Latency is available (to the right of Standard Monitoring Latency).
If not then you have to change some of the processing settings until it is.

Low Latency available and still no Z on Main? Then make sure (in I/O Setup) that your main output is actually routed to your audio interface.

 

[Midiboy]

Here's what is weird. Like I said, my buffer was 128 and DOP was 2048. I changed my buffer to 512 and then back to 128 and it came back. But hey...I'm happy now. Thank you for your help!

 

[SwitchBack]

Funny, I checked a few songs and had one come up without the Z on Main. Toggling the output assignment to 'None' and back to the interface outputs brought it back. So apparently a little reset is needed, sometimes

 

[Midiboy]

That's technology for ya.