• Hi and welcome to the Studio One & Studio Pro User Forum!

    Please note that this is an independent, user-driven forum and is not endorsed by, affiliated with, or maintained by Fender. Learn more in the Welcome thread!

FaderPort - Console View

jimmy_thesaint

New member
New here, looking for advice

I have a FaderPort 16 and Studio 1 Pro. I'm sure the Mix Management buttons on the FaderPort should also display on the Console, is that correct? E.g. press Buss button on FP and both the FP and Console display the same?

When I press the Buss button on the FP, the FP responds with the busses, but the Console remians the same view

In reverse, if I select only busses or audio in the console, the FP responds accordingly

It seems like I'm missing a setting somewhere....?

Any advice welcomed
 
New here, looking for advice

I have a FaderPort 16 and Studio 1 Pro. I'm sure the Mix Management buttons on the FaderPort should also display on the Console, is that correct? E.g. press Buss button on FP and both the FP and Console display the same?

When I press the Buss button on the FP, the FP responds with the busses, but the Console remians the same view

In reverse, if I select only busses or audio in the console, the FP responds accordingly

It seems like I'm missing a setting somewhere....?

Any advice welcomed
Hi Jim, unfortunately, the console image doesnt display (jump to) banks, or busses selected from the FP8 or 16. Of course if you press [Channel Select], you'll see the selection only if its already on screen. That's too bad, as it wont visibly slave to selections or buss selections. If you touch a fader and not even move it yet, the fader will highlight, but again it wont jump to a channel off screen. You have to position the on-screen console visibly into viewing that channel. Bummer.
 
Back
Top