how to make it work maschine mikro mk3 and studio one 5?

[maranpis]

Hi guys, I'm here trying to find a solution to use the Maschine Mikro MK3 in Studio One 5. Mainly, I’ve followed these steps:

1. I went to the Mikro MK3’s controllers and set it to Mackie and closed it.

2) Then, I configured the Mackie in Studio One.

I have the maschine mikro mk3 in midi mode

However, when I press the pad C1, what happens is that the track activates solo mode, but I can't get the notes to sound in Impact. Does anyone know what I'm doing wrong?

 

[sintil8]

Hiya,
try setting maschine up as a keyboard. All channels active, tick the seperate midi chnls box.
The MCU is for when you use Maschine as a Vst, as far as remember, and does not work the Play stop etc when in Midi mode?

Load impact, switch Maschine to Midi mode and select Group C (this alignes the notes being triggered to match impact a bit better ) and tap a few of the pads. If this works you may want to go into the Masch control software and change the note settings to aligne them with Impact note settings as required.

Hopefully this might get you started, the YTube vid below is for Screwbase but has some good info. Cut to 3 min 50 for more info on setting up Maschine via the controller software. Cut out of the vid at about 9min 30 as it's CBase stuff.

Setup Maschine as a MIDI Controller for Groove Agent, Cubase and synths! 🥁🥁🥁#cubase #maschine

You asked for it so here it is: How to set up your Maschine as a midi controller for Groove Agent, Groove Agent SE or any other synth in Cubase or any other ...

www.youtube.com

Best regards hope this helps

 

[maranpis]

Hiya,
try setting maschine up as a keyboard. All channels active, tick the seperate midi chnls box.
The MCU is for when you use Maschine as a Vst, as far as remember, and does not work the Play stop etc when in Midi mode?

Load impact, switch Maschine to Midi mode and select Group C (this alignes the notes being triggered to match impact a bit better ) and tap a few of the pads. If this works you may want to go into the Masch control software and change the note settings to aligne them with Impact note settings as required.

Hopefully this might get you started, the YTube vid below is for Screwbase but has some good info. Cut to 3 min 50 for more info on setting up Maschine via the controller software. Cut out of the vid at about 9min 30 as it's CBase stuff.

Setup Maschine as a MIDI Controller for Groove Agent, Cubase and synths! 🥁🥁🥁#cubase #maschine

You asked for it so here it is: How to set up your Maschine as a midi controller for Groove Agent, Groove Agent SE or any other synth in Cubase or any other ...

www.youtube.com

Best regards hope this helps

Thanks! Switching to group C worked! It was an alignment problem.